26

Wrench Tips #26:

Back Purge Your TIG Welds The Cheap Way

by Dave Coleman

When you're welding tubing, the backside of your weld (inside the tube) is still exposed to oxygen and oxidation reactions can weaken your weld. Even when strength isn't a big concern, with some materials (like stainless) the oxidation will build up a large, hard lump on the inside of the pipe, which can actually be a real issue for flow if you're welding something relatively small and flow-sensitive like a header primary.

The standard solution is some combination of Solar Flux (a paste that creates an inert shielding gas when heated by the welder) and/or back purging.

Back purging is simply using a second bottle of inert gas to flood the inside of the tube and flush out the oxygen. Kojima showed some hot, back purging action a few weeks ago, but Tim Taylor showed us some back purging tricks that let you use less of your expensive shielding gas while he was welding up some of the Miatabusa's exhaust.

Wrench Tips #26: Backpurge Your TIG Welds The Cheap Way

The trick is simple: use a cheap rubber glove to seal the ends of the pipe. This lets you easily visualize the gas pressure inside the pipe, so you can adjust the flow rate on your regulator to keep the glove barely inflated. This is just enough flow that you can be confident no oxygen is leaking into the pipe. Keep the purge bottle nearby so you can easily adjust the flow rate as your welding seals up leaks in the pipe.

 

Wrench Tips #26: Backpurge Your TIG Welds The Cheap Way

Also, use blue painters tape to seal unwelded joints and to seal around the gloves. Other tapes are more likely to leave adhesive residue when exposed to heat. Get it hot enough, and painters tape will leave residue too, so don't weld too close to it.

 

Wrench Tips #26: Backpurge Your TIG Welds The Cheap Way

Feeding the gas into the pipe is as simple as poking a hole in the glove, slipping the gas line in, and taping it up. 

 

Wrench Tips #26: Backpurge Your TIG Welds The Cheap Way

Since the glove inflation indicates pressure inside the pipe, you can often run very low flow rates, saving you from wasted purge gas.  

 

Wrench Tips #26: Backpurge Your TIG Welds The Cheap Way

 

 

Want to read more of this nonsense? Click Wrench Tips on the Tech dropdown, just like this here picture:

How to find Wrench Tips

 

 

 

 

 

Bookmark and Share
Comments
8695Beaters
8695Beaterslink
Wednesday, October 26, 2011 9:03 AM
I'm sure Tim gets asked this a lot, but does he grunt when he's finishing up one of these incredulous project? You know "oh oh oh oh oh" from a certain 90's sitcom?
Rockwood
Rockwoodlink
Wednesday, October 26, 2011 10:41 AM
Awesome. My 4 foot tank costs about $50-60 to refill, and doesn't last long as it is. Always wanted to backpurge my pipes (hehe), but never have because I can see the dollar signs rolling around in my head, and I'm almost always welding mild steel.
Post Comment Login or register to post a comment.

MotoIQ Proudly Presents Our Partners:

© 2014 MotoIQ.com