Project Cars

Project 350Z- Testing the AEM Induction Cold Air Intake

by Mike Kojima

In our last trip to the dyno, we tested  AEM's Short Ram intake on our 350Z.  We were surprised to find a small but definite power increase over another leading intake that was already on the car.  Since AEM makes a long runner Cold Air Intake as well as the Short Ram, we decided to test that as well as an interesting contrast between the two vastly different intake designs.


 

Project 350Z- Increasing Oil Capacity with Jim Wolf Technology

by Mike Kojima

We have been working on getting more power out of Project 350Z's VQ35DE engine in our latest series of articles.  With success coming bit by bit, we decided that we had to give the oiling system a little help.  Some 350Z's with highly modified suspension and sticky tires have suffered from engine oiling issues when driven on the track hard.  The oil had simply sloshed away from the pickup under hard cornering allowing the oil pump to suck air.  Since engine bearings are made of soft metal and depend on a hydrodynamic layer of pressurized oil to prevent damage, any interruption of oil pressure caused damage very quickly.


 

Project 350Z - Testing AEM's Short Ram Air Intake

by Mike Kojima

When we first got Project 350Z as a well used and beat up car, one of the mods the car came with was an Injen Cold Air Intake.  Since Injen intakes have a pretty decent rep we simply left in on the car.  However, when we installed the intake manifold spacer, we noted that the manifold was full of dirt and that our engine was a little low on compression for the amount of miles that it had.


 

Project 350Z - Finding More Power with MotorDyne Engineering

by Mike Kojima

In looking for more low hanging horsepower fruit for Project 350Z, we decided to try an intake manifold plenum spacer from MotorDyne Engineering.  The 350Z's VQ35DE engine has a very thin intake manifold plenum that slopes toward the front of the engine to clear the low hood line.  Although this is good for styling, the engine would prefer more plenum volume and the flow to the front most cylinders is somewhat choked off due to the low overhanging plenum wall.


 

Project Silvia’s Girlfriend: Part 3 - Making it Pretty

by Dave Coleman

It only takes a short glance at any car I’ve ever owned (or any house, or my closet…) to realize I’m the wrong person for this third step on Project Silvia’s Girlfriend. Nevertheless, Sarah wanted a car that was up to her borderline obsessive standards of cleanliness and perfection, so I had to do my best to at least look like I was trying to achieve that. I’ve seen lots of pretty cars before, and I have a reasonable theoretical grasp on how they got that way, so I considered myself up to the task… at least at the beginning.


 

350Z - Boosting Power With DC Sports and Berk Technology

by Mike Kojima

In the past installments of Project 350Z, we took a look at getting the car's suspension and brakes up to snuff.  With the car handling and stopping well, we turned our focus to freeing up some more power.  Since the car is mostly a budget track day beater, we decided against forced induction options for now because making a high power forced induction motor reliable under continual hot lapping conditions is a somewhat expensive proposition.

To keep a decent budget balance, we decided to focus on some good bolt on's to see what we could get from our 350Z.  For our first step we decided to free up the exhaust side of things with headers and an exhaust from DC Sports and free flow cats from Berk Technology.


 

Page 4 of 4First   Previous   1  2  3  [4]  Next   Last   

MotoIQ Proudly Presents Our Sponsors:

© 2018 MotoIQ.com