28

 

AEM has released V1.7 software for the AQ-1 data logger, which increases the amount of AEM devices that the AQ-1 is able to data log through its AEMnet CANbus network. The software is available from the Downloads section and AQ-1 Data Logger page of the aemelectronics.com website, and can also be downloaded using the in-app updater, which will prompt users to download the new version of software.

 

 

New devices that the AQ-1 will accept through AEMnet include X-Series gauges, which can open up analog channels used for pressures and temps to monitor other 0-5v sensors, the Vehicle Dynamics module, which adds GPS/GLONASS for track mapping in addition to vehicle acceleration, pitch, roll and yaw, and expanded channels from all Infinity ECU models using any Firmware version.


 

About AEM

Advanced Engine Management’s performance electronics are Engineered to Outperform. The company designs, manufactures and assembles engine management systems, wideband air/fuel systems, water/methanol injection systems, data acquisition systems, performance gauges, boost controllers, ignition components, fuel delivery components and adjustable cam gears at its corporate headquarters in Hawthorne, CA.

 

Bookmark and Share
Comments
rawkus
rawkuslink
Sunday, August 28, 2016 4:08 PM
What is measured to be able to get points on a turbo efficiency map?
Hentai
Hentailink
Wednesday, August 31, 2016 3:39 AM
rawakus it requires pressure ratio, really needs to be between the compressor inlet and outlet and mass air flow.
Hentai
Hentailink
Wednesday, August 31, 2016 3:41 AM
So they actually have it finally where data can go out of this to ecu's though canbus?
I really hope so, because OBD2 never came to be with the AQ-1 and that was a let down.
Post Comment Login or register to post a comment.

MotoIQ Proudly Presents Our Partners:



© 2018 MotoIQ.com